Please not that PrintaKit is out of Stock at the moment.

37 well matched tools

3D printing gives you a lot of freedom. To experience the whole potential of 3D printing you need more than a printer. Finding suitable tools for 3D printing can be challenging. That´s why we offer you a high quality toolkit, that includes everything you really need to prepare, maintain and finish your print. PrintaKit takes care of all stages of 3D printing: Preparation – Printing – Aftercare – Service. In addition to the well selected assortment, you have enough space for further accessories in this robust case.


Make sure that you calibrate your printbed once every five prints. Use the provided cards for the correct distance between the nozzle and the printbed. Follow the manual provided with your 3D printer.


After your print has finished take the printbed out of the 3D printer and place it on a stable surface. Hold the printbed tight with one hand (use the gloves for extra grip) and align the scraper as flat as possible to the printbed with your free hand. Then slowly and carefully push the scraper between the printbed and the 3D print. Depending on the size and shape of your print you will need to repeat the process at different positions or use the spatula to help. Be very gentle to not break your print or the blade.


This is a multi-purpose tool which you can use to cut small structures and support you don’t need. You can also use it to cut filament to a flat end for easier inserting into the extruder.


Ever had problems with a 3D print not sticking to the printbed or warping? PrintaFix Basic is the solution you need. It is an easy to apply solution that prevents 3D prints from warping.


The knife is suitable for fine grinding. This allows you to eliminate small errors or residuals very precisely.


To change the nozzle use the L-wrench (it will fit all standard nozzles). The allen key set can be used to dissemble or tighten the screws on your extruder or other parts of the 3D printer.


The tweezer is the perfect solution to remove stringing, oozing, whiskers or hairy prints.


If you can’t release the 3D print just by using the scraper, you can also use the spatula. Like the scraper it is intended to release large 3D prints. Raise the print a bit with the scraper, then carefully insert the Spatula. With a bit of pressure and jiggling you should be able to release more of the 3D print. Repeat on different sides until the 3D print comes off in one piece.


Heat the nozzle and unload the filament. Insert the needle around 1 to 3cm (depending on your hot end) into the hot nozzle. Pull the needle out and repeat the process.


3D prints with overhangs require support structures to be printed successfully. After finishing the print use the long nose plier to easily remove these structures.

PrintaFix 100ml
Allen Key Set
5x Calibration Card

Long Nose Pliers
Side Cutter
Precision Knife
5x Cleaning Needles


Safety Googles
5x Extra Knife Blades
3x Extra Scrapper Blades