750g PLA Filament + 100ml PrintaFix
PLA (Polylactic acid) is the universal material for all 3D printer. It is easy to print on virtually any 3D printer and by far the most popular in the consumer market for FDM termoplastics. PLA can be printed at low temperatures and with PrintaFix or PrintaStick there is no need for a heated printbed to prevent warping. It has a good interlayer adhesion and low shrinkage and a slight shine to its appearance when the print is done. We recommend it for all decorative elements, prototypes for haptics or test prints.
PrintaFix is specially developed for FDM 3D printing to eliminate warping effective. You do not need any other adhesion agent anymore. PrintaFix is simpler to apply and has superior adhesion qualities compared to all other solutions on the market. The spray may be used on unheated and heated pressure beds.
Why high quality filament matters
AprintaPro filaments are produced 100% in Europe. We know our raw material suppliers and can keep a close eye on the quality we get. Cheaper filament manufacturers often don’t care and then small particles contaminate the filament. These particles will then either be visible in your 3D print or worse clog your nozzle. We only use high quality raw materials for our PLA and colouring pigments so your prints won’t dull during the print or after you put your 3D print on display. We set ourselfs high standards and only accept minimal tolerances in the filament diameter.
Recommended printsettings for PLA
|180-220°C||0°C* | >65°C||not required|
|PrintaFix | PrintaStick||100%||standard brass**|
|up to 70mm/s||>0.1mm||100%|